ECS A785GM-AD3 (V1.0) Specifications download pdf (Page 15)

Installing the Motherboard

1 Install your CPU. Pull up the lever away from

the socket and lift up to 90-degree angle.

2 Locate the CPU cut edge (the corner with

the pin hold noticeably missing). Align and

insert the CPU correctly.

3 Press the lever down and apply thermal

grease on top of the CPU.

4 Put the CPU Fan down on the retention mod-

ule and snap the four retention legs of the

cooling fan into place.

5 Flip the levers over to lock the heat sink in

place and connect the CPU cooling Fan power

cable to the CPUFAN connector. This com-

pletes the installation.

CPU Installation Procedure

The following illustration shows CPU installation components.

To achieve better airflow rates and heat dissipation, we suggest that you

use a high quality fan with 4800 rpm at least. CPU fan and heatsink

installation procedures may vary with the type of CPU fan/heatsink sup-

plied. The form and size of fan/heatsink may also vary.

Installing Memory Modules

This motherboard accommodates four memory modules. It can support four 240-pin

DDR3 1600/1333/1066/800. The total memory capacity is 32 GB.

DDR3 SDRAM memory module table

Do not remove any memory module from its antistatic packaging until

you are ready to install it on the motherboard. Handle the modules only

by their edges. Do not touch the components or metal parts. Always

wear a grounding strap when you handle the modules.

You must install at least one module in any of the four slots. Each module can be

installed with 8 GB of memory.

Memory module Memory Bus

DDR3 800 400 MHz

DDR3 1066 533 MHz

DDR3 1333 667 MHz

DDR3 1600 800 MHz

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 85 86

No comments

ECS A785GM-AD3 (V1.0) Specifications Page 15