ECS H67H2-M3 (V1.0) Specifications download pdf (Page 18)

Installing the Motherboard

Installing Memory Modules

This motherboard accommodates two memory modules. It can support two 240-pin

DDR3 1333/1066. The total memory capacity is 8 GB.

You must install at least one module in any of the two slots. Total memory capacity

is 8 GB.

DDR3 SDRAM memory module table

Installation Procedure

Refer to the following to install the memory modules.

1 This motherboard supports unbuffered DDR3 SDRAM .

2 Push the latches on each side of the DIMM slot down.

3 Align the memory module with the slot. The DIMM slots are keyed with

notches and the DIMMs are keyed with cutouts so that they can only be

installed correctly.

4 Check that the cutouts on the DIMM module edge connector match the

notches in the DIMM slot.

5 Install the DIMM module into the slot and press it firmly down until it

seats correctly. The slot latches are levered upwards and latch on to

the edges of the DIMM.

6 Install any remaining DIMM modules.

Do not remove any memory module from its antistatic packaging until

you are ready to install it on the motherboard. Handle the modules only

by their edges. Do not touch the components or metal parts. Always wear

a grounding strap when you handle the modules.

1. To achieve better airflow rates and heat dissipation, we suggest

that you use a high quality fan with 3800 rpm at least. CPU fan and

heatsink installation procedures may vary with the type of CPU fan/

heatsink supplied. The form and size of fan/heatsink may also vary.

2. DO NOT remove the CPU cap from the socket before installing a

CPU.

3. Return Material Authorization (RMA) requests will be accepted

only if the motherboard comes with the cap on the LGA1155 socket.

Memory module Memory Bus

DDR3 1066 533 MHz

DDR3 1333 667 MHz

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 83 84

No comments

ECS H67H2-M3 (V1.0) Specifications Page 18