ECS Motherboard P33T-A V1.0 Specifications download pdf (Page 18)

Installing the Motherboard

Installing Memory Modules

This motherboard accomodates four memory modules. It can support four 240-pin

DDR2 800/667. The total memory capacity is 16 GB.

You must install at least one module in any of the four slots. Each module can be

installed with 4 GB of memory; total memory capacity is 16 GB.

DDR2 SDRAM memory module table

DDR2 800 400 MHz

Memory module Memory Bus

DDR2 667 333 MHz

Do not remove any memory module from its antistatic packaging

until you are ready to install it on the motherboard. Handle the

modules only by their edges. Do not touch the components or metal

parts. Always wear a grounding strap when you handle the modules.

Installation Procedure

Refer to the following to install the memory modules.

1 This motherboard supports unbuffered DDR2 SDRAM .

2 Push the latches on each side of the DIMM slot down.

3 Align the memory module with the slot. The DIMM slots are keyed with

notches and the DIMMs are keyed with cutouts so that they can only be

installed correctly.

4 Check that the cutouts on the DIMM module edge connector match the

notches in the DIMM slot.

5 Install the DIMM module into the slot and press it firmly down until it

seats correctly. The slot latches are levered upwards and latch on to

the edges of the DIMM.

6 Install any remaining DIMM modules.

The four DDR2 memory sockets (DIMM1, DIMM2, DIMM3, DIMM4) are divided

into two channels and each channel has two memory sockets as following:

Channel 0: DIMM1, DIMM2

Channel 1: DIMM3, DIMM4

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 57 58

No comments

ECS Motherboard P33T-A V1.0 Specifications Page 18