ECS P43T-A2 (V1.0) Specifications download pdf (Page 22)

Installing the Motherboard

F_USB1~4: Front Panel USB headers

The motherboard has four USB ports installed on the rear edge I/O port array.

Additionally, some computer cases have USB ports at the front of the case. If you

have this kind of case, use auxiliary USB connector to connect the front-mounted

ports to the motherboard.

Please make sure that the USB cable has the same pin assignment as

indicated above. A different pin assignment may cause damage or system

hang-up.

1 USBPWR Front Panel USB Power

2 USBPWR Front Panel USB Power

3 USB_FP_P0- USB Port 0 Negative Signal

4 USB_FP_P1- USB Port 1 Negative Signal

5 USB_FP_P0+ USB Port 0 Positive Signal

6 USB_FP_P1+ USB Port 1 Positive Signal

7 GND Ground

8 GND Ground

9 Key No pin

10 NC Not connected

Function

Pin Signal Name

SATA1~6: Serial ATA connectors

These connectors are used to support the new Serial ATA devices for the highest date

transfer rates (3.0 Gb/s), simpler disk drive cabling and easier PC assembly. It elimi-

nates limitations of the current Parallel ATA interface. But maintains register com-

patibility and software compatibility with Parallel ATA.

1 Ground 2 TX+

3 TX- 4 Ground

5 RX- 6 RX+

7 Ground - -

Pin Signal Name

CD_IN: Analog Audio Input connector

Pin Signal Name Function

1 CD_L CD In left channel

2 GND Ground

3 GND Ground

4 CD_R CD In right channel

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 61 62

No comments

ECS P43T-A2 (V1.0) Specifications Page 22