ECS P43T-A2 (V1.0) Specifications download pdf (Page 28)

Installing the Motherboard

Front Panel Header

The front panel header (F_PANEL) provides a standard set of switch and LED headers

commonly found on ATX or Micr ATX cases. Refer to the table below for informa-

tion:

Supporting the reset function requires connecting pin 5 and 7 to a momentary-

contact switch that is normally open. When the switch is closed, the board resets and

runs POST.

Connecting pins 2 and 4 to a single or dual-color, front panel mounted LED provides

power on/off, sleep, and message waiting indication.

Connecting pins 1 and 3 to a front panel mounted LED provides visual indication that

data is being read from or written to the hard drive. For the LED to function properly,

an IDE drive should be connected to the onboard IDE interface. The LED will also

show activity for devices connected to the SCSI (hard drive activity LED) connector.

Supporting the power on/off function requires connecting pins 6 and 8 to a momen-

tary-contact switch that is normally open. The switch should maintain contact for at

least 50 ms to signal the power supply to switch on or off. The time requirement is

due to internal de-bounce circuitry. After receiving a power on/off signal, at least two

seconds elapses before the power supply recognizes another on/off signal.

This concludes Chapter 2. The next chapter covers the BIOS.

Power/Sleep/Message waiting LED

Hard Drive Activity LED

Reset Switch

Power Switch

Pin Signal Function Pin Signal Function

1 HD_LED_P Hard disk LED (+)

2 FP PWR/SLP *MSG LED (+)

3 HD_LED_N Hard disk LED (-)

5 RST_SW_N Reset Switch (-)

7 RST_SW_P Reset Switch (+)

9 RSVD Reserved

4 FP PWR/SLP *MSG LED (-)

6 PWR_SW_P Power Switch (+)

8 PWR_SW_N Power Switch (-)

10 Key No pin

* MSG LED (dual color or single color)

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 61 62

No comments

ECS P43T-A2 (V1.0) Specifications Page 28