ECS P67H2-A3 (V1.0) Specifications download pdf (Page 21)

Installing the Motherboard

F_USB1~2(USB 2.0): Front Panel USB 2.0 headers

The motherboard has three USB 2.0 headers supporting six USB 2.0 ports. Addition-

ally, some computer cases have USB 2.0 ports at the front of the case. If you have

this kind of case, use auxiliary USB 2.0 connector to connect the front-mounted

ports to the motherboard.

1 USBPWR Front Panel USB Power

2 USBPWR Front Panel USB Power

3 USB_FP_P0- USB Port 0 Negative Signal

4 USB_FP_P1- USB Port 1 Negative Signal

5 USB_FP_P0+ USB Port 0 Positive Signal

6 USB_FP_P1+ USB Port 1 Positive Signal

7 GND Ground

8 GND Ground

9 Key No pin

10 USB_FP_OC0 USBOC-

Pin Signal Name Function

SATA3~6: Serial ATAII connectors

These connectors are used to support the Serial ATA 3Gb/s devices, simpler disk drive

cabling and easier PC assembly. It eliminates limitations of the current Parallel ATA

interface. But maintains register compatibility and software compatibility with Par-

allel ATA.

1 Ground 2 TX+

3 TX- 4 Ground

5 RX- 6 RX+

7 Ground - -

Pin Signal Name

Unlike F_USB1/3 in this mainboard, F_USB2 supports EZ Charger technology, pro-

vides about 1A current than general USB port in off mode for USB devices. It is useful

and excellent, especially for the iPhone, iPad and iPod touch devices that need a

large amount of current for faster recharging within less time.

Please make sure that the USB cable has the same pin assignment as

indicated above. A different pin assignment may cause damage or system

hang-up.

CASE: Chassis Intrusion Detect Header

Short Chassis cover is removed

Open Chassis cover is closed

This detects if the chassis cover has been removed. This function needs a chassis

equipped with instrusion detection switch and needs to be enabled in BIOS.

Pin 1-2 Function

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 79 80

No comments

ECS P67H2-A3 (V1.0) Specifications Page 21